Gys WF 51 handleiding
Handleiding
Je bekijkt pagina 31 van 116
EN
31
User manual
WF 51
Translation of the original
instructions
OPTIONAL TROLLEY
075498
DEFECTS: CAUSES & SOLUTIONS
SYMPTOMS POSSIBLE CAUSES SOLUTIONS
The ow rate of the welding wire is not
constant.
Clogs blocking the opening.
Clean the contact tube or replace it with non-
stick material.
The wire is slipping on the rollers. Reapply the non-stick product.
One of the rollers is spinning. Check the tightness of the roller screw.
The torch cable is twisted.
The torch cable should be as straight as
possible.
The unwinding mechanism is not working. The spool’s brake or roller is too tight. Loosen the brake and rollers.
Incorrect unwinding of the wire.
Dirty or damaged wire guide. Clean or replace.
Roller pin key is missing. Reposition the pin in its slot.
Spool’s brake is too tight. Release the brake.
No current or wrong welding current.
Incorrect mains outlet connection.
Check the plug connection and verify that the
plug is connected to the power supply.
Poor earth connection.
Check the earthing cable (its connection and
the condition of the clamp).
No power. Check the torch trigger.
The wire jams after passing through the
rollers.
Crushed wire guide sheath.
Check the wire-guide sheath and body of the
torch..
Wire blockage in the torch. Replace or clean.
No capillary tube. Check that the capillary tube is present.
Wire speed too high. Reduce the wire speed.
The weld bead is porous.
The gas ow is insucient.
Adjustment range from 15 to 20 L / min.
Clean the base metal.
Gas cylinder empty. Replace it.
Unsatisfactory gas quality. Replace it.
Air circulation or wind inuence. Avoid draughts and protect the welding area.
Gas nozzle is too clogged. Clean or replace the gas nozzle.
Bad wire quality. Use a wire suitable for MIG/MAG welding.
Condition of the welding surface is too poor
(rusted, etc.).
Clean the workpiece before welding.
The gas is not connected.
Check that the gas is connected to the power
source’s inlet.
Excessive sparks.
Arc voltage is too low or too high. See welding settings.
Poor earth connection.
Check and position the earth clamp as close
as possible to the area to be welded.
Insucient gas protection. Adjust the gas ow.
No gas coming from the torch. Poor gas connection.
Check the connections of gas inlets.
Check that the solenoid valve is working.
Error while downloading.
The data on the USB stick is incorrect or
corrupted.
Check your data.
Bekijk gratis de handleiding van Gys WF 51, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gys |
| Model | WF 51 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16060 MB |
