Handleiding
Je bekijkt pagina 23 van 37
+ / - button
This function is only available for some models.
●
NOTE
UV button
●
●
●
no display
(horizontal louvers stops
at current position)
●
●
●
NOTE
Press " + " or " - " button once increase or decrease
set temperature 1℃(℉). Holding " + " or " - " button,
2s later, set temperature on remote controller will
change quickly. On releasing button after setting is
finished, temperature indicator on indoor unit will
change accordingly.
Press "Wifi" button to turn on WiFi function, "Wifi"
icon will be displayed on the remote controller;
Hold "Wifi" button for 5s to turn off WiFi function
and "Wifi" icon will disappear.
Under off status, press "Mode" and "Wifi" buttons
simultaneously for 1s, WiFi module will restore
factory settings.
UD-swing button
Press this button can sel wn swing angle.
Fan blow angle can be selected circularly as below:
When selecting " ", air conditioner is blowing
fan automatically. Horizontal louver will automat-
When selecting " 、 、 、 、 " , a ir condi-
tioner is blowing fan at fixed position. Horizontal
louver will stop at the fixed position.
Wifi button
●
" " function is not applied on this model.
NOTE
Button
●
NOTE
Hold " " button above 2s to set your required
swing angle. When reaching your required
angle, release the button.
no display
This button is only available for the model with such
function.
LR-swing button
Fan blow angle can be selected circularly as below:
position)
(stops at current
Press this button continuously more than 2s, the main
unit will swing back and forth from up to down, and
then loosen the button, the unit will stop swinging and
present position of guide louver will be kep t immedi-
ately.
Under swing up and down mode, when the status is
switched from off to , if press this button again 2s
later, status will switch to off status directly; if
press this button again within 2s, the change of swing
status will also depend on the circulation sequence
stated above.
●
●
●
●
●
function is for limiting power of the whole unit.
Press this button, the remote controller will circularly
display as the following:
blank
100%
No Setting
- 19 -
Maximum power limited under the mode is
lower than that of mode.
If you want to cancel the power limiting function,
press the button till the icon in remote contro-
ller is not displayed.
When the remote controller is turned o ff, power
limiting function is cancelled. If you want to
activate the function, please repress the button.
If the current power is lower than the maximum
power of mode, then the power will not be limit-
ed after entering into such mode.
For the model with one outdoor unit and two indoor
units, if any one of indoor units enters into power
limit
ing function, the outdoor unit will enter into the
set limiting power mode of indoor unit; when two
indoor units enter into power limiting mode, then
the power of outdoor unit will be limited according
to the lower power of the two indoor units.
This function is only available for some models.
60%
75%
(Not applicable for this model)
UV
Press this button to select your required operation function
as below:
● When selecting " " function." with remote controller,
air conditioner will turn on the UV function.
● When selecting " " or "no display" with remote
controller, air conditioner will turn off the UV function.
Bekijk gratis de handleiding van Gree GWH18PZ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gree |
| Model | GWH18PZ |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 3700 MB |
