GLP impression X5 IP handleiding
Handleiding
Je bekijkt pagina 23 van 41
www.glp.de X5 IP
Rev. 20250129-01 23
● On: The display stays on constantly. This setting can be useful if you are
configuring or servicing the fixture.
● Off: The display will automatically switch off after a few seconds even if the
fixture is not receiving a valid control signal or if it has detected an error.
Pressing any button turns on the display again.
Display Orientation
Lets you select Normal, Upside-down or Auto display orientation.
If Display Orientation is set to Auto, changing the display orientation by pressing
UP and DOWN at the same time will only change the display orientation until the
next power cycle.
Hibernation
Lets you put the fixture into energy-saving mode and disables all electronic
components apart from the DMX receiving module.
You can take the fixture out of hibernation mode with a power off/on cycle, via RDM
or using the Special / Control DMX channel. If you do this, the fixture will perform a
fixture reset before returning to normal operation.
Load User Settings
Lets you load different custom fixture configurations or return the fixture to the
default fixture settings.
To save a custom setting preset from 1 to 3, see Service
→
Advanced
→
Save Settings.
● Load User Settings 1 to 3 loads one of three specific custom fixture settings. You
must confirm the function for 3 seconds before the new settings are loaded (see
Fixture Settings
→
Load User Settings).
● Save User Settings 1 to 3 saves the current fixture settings as a set of user
settings. You must confirm the function for 2 seconds in order to save the
settings as one of the three custom settings presets (see Service
→
Advanced
→
Save User Settings).
Note: The Load User Setting Presets and Load User Setting Defaults commands
will only affect settings in the Fixture Settings group and will not affect DMX
Address, Control Mode, Protocol Type, IP Settings, etc. This helps avoid loss of
communication with the controller.
Information
The Information submenu provides readouts of all relevant information such as the
error list if any errors have been detected, the fixture’s serial number, firmware
version, device info, device hours counter, power cycles counter, DMX input
monitor, signal quality etc.
Bekijk gratis de handleiding van GLP impression X5 IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | impression X5 IP |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4489 MB |
