GLP impression X5 IP handleiding
Handleiding
Je bekijkt pagina 11 van 41
www.glp.de X5 IP
Rev. 20250129-01 11
Note: To obtain the desired color temperature on the CTC channel, you must set all
Color Mix channels to 100%. If they are not at 100%, the system will mix color
relative to the selected white point of the CTC channel.
The CTC channel affects all the fixture’s modules. Setting the CTC channel to a
specific color temperature will affect the open white of the Main module and Sub
module.
Color Quality Control (CQC)
The CQC channel lets you modify the spectral mix of the white output in order to
achieve a balance between better color rendering or higher output intensity. The
following options are available:
● High Quality (HQ) deploys multiple LEDs to create a richer light spectrum that
gives improved color rendering but also slightly lower output. Color is mixed
with priority given to the best white color rendering quality. Saturated colors will
have maximum saturation at DMX 000 and will smoothly become unsaturated
until they reach 0% saturation (= white) at DMX value 127.
● High Output (HO) gives higher output intensity but reduced color rendering
performance. Color is mixed with priority given to the highest output in white.
Saturated colors will have maximum saturation at DMX 255 and will smoothly
become unsaturated until they reach 0% saturation (= white) at DMX value 128.
While using white light, the CQC channel lets you change between white with
priority on high-quality color rendering and white with priority on highest output.
Additionally, the CQC channel lets you smoothly desaturate colors. If you have set a
saturated color in the color mix, the CQC channel lets you smoothly desaturate the
color from saturated to fully unsaturated (i.e. white).
Note: The CQC channel affects all the fixture’s modules. Setting the CQC channel to
a specific value will affect the colors of the Main module and Sub module.
Note: The HO and HQ CQC options only affect the color mix if the fixture is in RGB
or x;y Color Mix mode. In all other Color Mix modes this setting has no effect.
Magenta/Green Shift (M/G Shift)
The Magenta/Green Shift channel lets you move the color coordinate of a white
point, a mixed color or a selected CTC color along a vertical line on the color
temperature curve in all three Color Mix modes. The corresponding white point is
either shifted towards Green or Magenta.
If M/G Shift is enabled, it immediately affects all mixed colors as well as the color
temperature that is selected on the CTC channel. It has no effect on the colors of
the virtual color wheel.
Note: The M/G Shift channel affects the entire fixture. Setting the M/G Shift channel
to a specific value will affect the output of the Main module and Sub module.
Color wheel
The impression X5 IP features a virtual color wheel channel that gives quick access
to a wide range of LEE-referenced colors in all three Color Mix modes. Color wheel
Bekijk gratis de handleiding van GLP impression X5 IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | impression X5 IP |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4489 MB |
