GLP impression X5 IP Bar 1000 handleiding

Verlichting

GLP

84 pagina's

PDF beschikbaar

Handleiding

German Light Products® X5 IP Bar 1000

Rev. 20240207-01 23

Display Orientation

Lets you select Normal, Upside-down or Auto control panel display orientation.

If Display Orientation is set to Auto, changing the display orientation by pressing UP and

DOWN at the same time will only change the display orientation until the next power

cycle.

Hibernation

Lets you put the fixture into energy-saving mode and disables all electronic

components apart from the DMX receiving module.

You can take the fixture out of hibernation mode with a power off/on cycle, via RDM

or using the Special / Control DMX channel. If you do this, the fixture will perform a

fixture reset before returning to normal operation.

Load User Settings

Lets you load different custom fixture configurations or return the fixture to the default

fixture settings.

To save a custom setting preset from 1 to 3, see Service

→

Advanced

→

Save_Settings.

● Load User Settings 1 to 3 loads one of three specific custom fixture settings. You

must confirm the function for 3 seconds before the new settings are loaded (see

Fixture Settings

→

Load User Settings).

● Save User Settings 1 to 3 saves the current fixture settings as a set of user settings.

You must confirm the function for 2 seconds in order to save the settings as one of

the three custom settings presets (see Service

→

Advanced

→

Save User Settings).

Note: The Load User Setting Presets and Load User Setting Defaults commands will only

affect settings in the Fixture Settings group and will not affect DMX Address, Control

Mode, Protocol Type, IP Settings, etc. This helps avoid loss of communication with the

controller.

Information

The Information submenu provides readouts of all relevant information such as the error

list if any errors have been detected, the fixture’s serial number, firmware version,

device info, device hours counter, power cycles counter, DMX input monitor, signal

quality etc.

Manual Control

This submenu gives different options for resetting the fixture manually. It can be helpful

for service or stand-alone issues.

● Reset All: Performs a full fixture reset to initialize all features and effects.

● Reset Tilt: Resets tilt only to initialize the tilt position.

● Reset Head: Resets all the features in the head.

Bekijk gratis de handleiding van GLP impression X5 IP Bar 1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.