GLP impression X5 IP Bar 1000 handleiding

Verlichting

GLP

84 pagina's

PDF beschikbaar

Handleiding

www.glp.de X5 IP Bar 1000

22 impression X5 IP Bar 1000 User Manual

If the fixture is set to Scene (Stand-alone) and if a stand-alone scene has been

stored in its memory using the Capture DMX Values command, it will display its

stand-alone scene at all times when it is powered on but not receiving a DMX

signal. You can therefore use this setting if you want fixtures to automatically start

stand-alone operation when you apply power to them.

● Capture DMX Values takes a snapshot of the DMX values that are currently being

received and stores them in the fixture’s memory as its captured scene. The fixture

will display this scene if it is set to Scene (Stand-alone) (see above) and is not

receiving a DMX signal.

Tilt invert

Increasing the tilt DMX value moves the head from its home position towards the front

of the fixture.

Changing the Tilt invert setting to ON inverts the tilt direction so that increasing the tilt

value turns the head towards the back of the fixture.

Position feedback

Tilt auto-correction (position feedback) is normally enabled (ON). Changing this

setting to OFF will disable the position feedback and auto-correction. If you need to

return tilt to its correct position, you must perform a reset.

Tilt disable

Tilt disable is normally OFF. Changing the Tilt disable setting to "Current disable" de-

activates tilt by disabling the tilt motor current.

Note: When changing from ON back to OFF to re-enable tilt movement, you must

carry out a reset before you can operate tilt normally.

Display Mode

Gives different behavior options for the display in the fixture’s control panel. This can

be helpful in case of errors or during service operations. Three settings are available:

● Auto (default): the display automatically switches off after a few seconds if the

fixture is receiving a valid control signal and has not detected an error. If the fixture

is not receiving a valid control signal, the display will flash. If the fixture has

detected an error, the display remains constantly on and shows the error.

● On: The display stays on constantly. This setting can be useful if you are configuring

or servicing the fixture.

● Off: The display will automatically switch off after a few seconds even if the fixture is

not receiving a valid control signal or if it has detected an error. Pressing any button

turns on the display again.

Bekijk gratis de handleiding van GLP impression X5 IP Bar 1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.