GLP impression X5 Bar 1000 handleiding
Handleiding
Je bekijkt pagina 24 van 84
www.glp.de X5 Bar 1000
24 impression X5 Bar 1000 User Manual
Note: The Load User Setting Presets and Load User Setting Defaults commands will only
affect settings in the Fixture Settings group and will not affect DMX Address, Control
Mode, Protocol Type, IP Settings, etc. This helps avoid loss of communication with the
controller.
Information
The Information submenu provides readouts of all relevant information such as the error
list if any errors have been detected, the fixture’s serial number, firmware version,
device info, device hours counter, power cycles counter, DMX input monitor, signal
quality etc.
Manual Control
This submenu gives different options for resetting the fixture manually. It can be helpful
for service or stand-alone issues.
● Reset All: Performs a full fixture reset to initialize all features and effects.
● Reset Tilt: Resets tilt only to initialize the tilt position.
● Reset Head: Resets all the features in the head.
Manual DMX
Gives individual control of the fixture using the fixture user interface. The menu timeout
function is disabled as long this menu is open.
● Manual Control: Manually sets a DMX value for each function.
● Reset Manual values: Resets all manual control values to default.
External DMX values will always have higher priority than manual control commands.
Disconnect the fixture from the data source when using manual control.
Note: When entering manual control, be prepared for the fixture to start moving.
Service
The Service menu is split into two levels: Service and Service Advanced. The Service
Advanced level is for trained technicians only. Read the information below carefully
before entering this level.
The Service menu contains the following items:
● Live Diagnostic: Calls up an overview of all main fixture information, signal quality
and settings. This can be helpful while troubleshooting or talking to GLP Service.
● iQ.Service Connect: Wakes up the integrated GLP iQ.Mesh Module for 5 minutes
and enables connectivity to the GLP iQ.Service App.
● Test All: Runs a test sequence of all LEDs for a quick test of the fixture. Press BACK to
stop the test sequence.
● Test Tilt: Runs a test sequence of tilt movement only. Press BACK to stop the test
sequence.
Bekijk gratis de handleiding van GLP impression X5 Bar 1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | impression X5 Bar 1000 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 13540 MB |
