GLP FUSION Stick FS16Z handleiding
Handleiding
Je bekijkt pagina 19 van 73
German Light Products®
Fusion FS 16Z User Manual Rev. 20240625-01 19
Installing on a rigging truss or similar structure
You can suspend an FS 16Z fixture from a rigging truss or pipe using either the fixture’s
adjustable Tilt Brackets or the Clamp Brackets that are available from GLP as optional
accessories for the FS 16Z. It is also possible to directly fix rigging clamps to the rear
mountings on the fixture without attaching either of the brackets.
If you are going to install the fixture hanging underneath a horizontal rigging truss or
pipe, you can fasten it to the truss using G-clamps. If you are going to install the fixture
in any other orientation (such as clamped above the truss), you must use half-coupler
clamps that completely surround the truss chord or pipe.
Installing on a truss using Tilt Brackets
To install the FS 16Z on a rigging truss or pipe using rigging clamps and the Tilt Brackets
supplied with the fixture:
1. Check that the truss or pipe is secure and can safely hold the weight of fixtures,
hardware and cables.
2. Fasten two Tilt Brackets to the back of the fixture as described in as described in
‘Attaching mounting brackets to the fixture’ on page 16.
3. Fasten two rigging clamps that are approved for the weight of the fixture to the Tilt
Brackets using two M12 bolts, grade 8.8 steel or better, that pass through the holes
arrowed in Figure 7.
4. Hold the fixture up to the truss chord, pass the rigging clamps around the truss
chord, then tighten the clamps to install the fixture securely on the truss.
5. In temporary installations, secure each fixture with a safety cable as described in ‘’
on page 16 if there is any risk that the fixture will cause injury or damage if it falls.
Installing on a truss using Clamp Brackets
To install the FS 16Z on a rigging truss or pipe using rigging clamps and optional Clamp
Brackets:
1. Check that the truss or pipe is secure and can safely hold the weight of fixtures,
hardware and cables.
2. See Figure 8. Bolt two rigging clamps A (G-clamps shown) that are approved for
the weight of the fixture to two Clamp Brackets B.
Figure 7. Holes for bolting rigging clamps to Tilt Brackets
Bekijk gratis de handleiding van GLP FUSION Stick FS16Z, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | FUSION Stick FS16Z |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 10685 MB |
