Genesis GLMT20BH handleiding
Handleiding
Je bekijkt pagina 7 van 32

FIG 2
8
FIG 3
6
7a
5
7b
FIG 4
ON
OFF
1
FIG 5
9
7
ENGLISH
OPERATION
WARNING: To reduce the risk of serious
personal injuries, read and follow all important safety
warning and instructions before using this tool.
WARNING: Always be sure that the tool
is switched off before insertion or removal of the battery
pack.
INSTALLING OR REMOVING THE
BATTERY PACK (FIG 2)
• To install the battery pack, slide the battery pack into
the bottom of the tool housing all the way until it locks
in place with a click, as shown in FIG 2. Lightly pull on
the battery to ensure it is locked into place and will not
accidentally fall out of the tool, causing an injury.
• To remove the battery pack, pull it away from the tool
while depressing the battery locking tab (8).
CHARGING THE BATTERY (FIG 3)
NOTE: Always check that the power supply corresponds
to the voltage on the ratings plate.
• Plug the charger (5) into a 120 Volt AC power source.
The green indicator light on the charger will illuminate,
confirming it is powered.
• Connect the charger to the battery (6) as shown in FIG
3. The red light on the charger will illuminate, indicating
that the battery is charging. Meanwhile, the power
indicator lights (7b) on the battery pack will flash,
indicating the charging status.
• All three indicate lights will turn solid green once
charging is complete.
• It is normal for the battery pack to become warm while
charging.
• If the battery pack is hot after continuous use in the
tool, allow it to cool down to room temperature before
charging. This will extend the life of your batteries.
NOTE: It takes approximately 80 minutes to fully
charge a completely discharged 2.0Ah battery pack.
BATTERY POWER INDICATOR (FIG 3)
There is a battery power indicator on the battery pack (6).
It has three green lights (7b). Depress the power indicator
button (7a) on the side to check the battery power level.
When all three lights illuminate, it indicates the battery is at
full power. The battery is at half full power when two lights
illuminate. When one light illuminates only, it indicates that
the battery is at low power level and requires immediate
charging.
WARNING: Always disconnect the
battery pack from the tool or place the switch in the
locked or off position before any assembly, adjustments
or changing accessories.
ON/OFF SWITCH ACTION (FIG 4)
To Start the Oscillating Multi-Tool,
slide the ON/OFF
switch (1) forward to ON position.
To Stop the Oscillating Multi-Tool, slide the ON/OFF
switch (1) backward to OFF position.
SPEED CONTROL (FIG 5)
The oscillating multi-tool features 5 speed settings,
controlled by the speed control (9). With the tool turned
ON, press the "+" button to increase the speed or the "-"
button to decrease it. The average speed range for each
setting is listed below.
Speed
Setting
1 2 3 4 5
Speed
(OPM)
10,000 12,000 14,000 16,000 19,000
Bekijk gratis de handleiding van Genesis GLMT20BH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Genesis |
Model | GLMT20BH |
Categorie | Niet gecategoriseerd |
Taal | Nederlands |
Grootte | 6650 MB |