GE JXRB67 handleiding

Handleiding

1234/ 4

Afdrukken

Je bekijkt pagina 3 van 4

3

STEP 3 INSTALL ADAPTER PLATE

• Install an adapter

plate over the

mounting plate on

the plenum with the

flange towards the

outside. Use 4

screws provided.

STEP 5 INSTALL ADAPTER PLATE,

HANGER BRACKETS

• Place the other adapter plate

over the 4 studs on the motor

with the flange facing outwards.

• Place hanger brackets over the

blower studs and secure with

nuts. One bracket in each

corner, as illustrated.

• Set the brackets to reach a

14-1/2” span between floor

joists, or adjust to mate with

the hole location in the floor

above.

• Secure the blower to the joists

with lag bolts provided.

STEP 4 CUT DUCTWORK HOLES

• Install the vent into the cabinet according to the

installation instructions packed with the vent.

• Place the 90° elbow over the adapter plate.

• Mark the location for a 6-1/2" round hole in the floor

of the cabinet.

NOTE: Check to be sure there is no interference

below the cabinet floor. The mounting plate on the

plenum can be shifted 3-1/2" to the left or right sides.

• The blower will fit between floor joists, 16” on

center. Or, provide a surface to attach the entire

assembly to the underside of the floor.

• Cut the hole through the cabinet and another hole

through the floor below.

Check for

Interference

Below Floor

90°

Elbow

Cut a

6-1/2" Dia.

Hole

STEP 6 CONNECT DUCTWORK

• Install a section of 6" round duct through the cabinet

floor and over the adapter plate on the motor. Tape

to seal the joint.

• Connect the plenum to the ductwork with 90° elbow.

• Install 3-1/4" x 10" duct to the blower outlet to reach

the outside wall or roof cap.

90°

Elbow

6"

Round

Duct

• DO NOT USE flexible plastic ducting.

• Use the straightest duct run possible.

• For satisfactory performance the duct run should not

exceed 150 ft. Refer to the table of equivalent lengths.

• Install ductwork so the piece of duct nearest the

downdraft unit slots INTO the next piece of the duct.

Secure the joints with self-tapping screws and apply

duct tape around the joints to ensure an airtight seal.

Duct Tape

Over Seam and Screw

Screw

Air

Flow

Install Adapter

Plate

1234/ 4

Bekijk gratis de handleiding van GE JXRB67, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Gerelateerde producten van GE (Niet gecategoriseerd)

Handleiding bekijken

GE GFC1065

Niet gecategoriseerd - handleiding

Handleiding bekijken

GE Profile PWL1126SS

Niet gecategoriseerd - handleiding

Andere merken in Niet gecategoriseerd