GE JXRB67 handleiding

Handleiding

1234/ 4

Afdrukken

Je bekijkt pagina 2 van 4

2

JXRB67 KIT

This kit provides for the installation of the blower and

motor outside of the cabinet, such as below the floor.

Use this kit for indoor remote installations only. It

must be installed in an accessible location.

STEP 1 PREPARE THE VENT

• Flatten the shipping box to use as a pad.

• Place the unit on its back and onto the protective

pad.

• Remove the 3 screws holding the control box on the

plenum. Retain screws.

• Cut the blower

leads approxi-

mately 3” from the

plug on the end of

the vent.

• Remove the blower

conduit by loosen-

ing the screw on the

fitting.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT - Save these instructions for local inspector’s use.

IMPORTANT - Observe All Governing Codes and Ordinances.

Note to Installer - Be sure to leave these instructions with the Consumer.

Note to Consumer - Keep these instructions for future reference.

Tools and Materials required:

• Chalk or Pencil

• Measuring tape

• Drill with appropriate bits

• 1/4", 3/8" and 7/16" Nut driver

• Junction box with cover (per local codes)

• Wire nuts

• Duct Tape

• Safety glasses

• 6" round 90° elbow

• 6" round duct, length to reach blower location

• 3-1/4" x 10" duct, sufficient length to reach the

outdoor wall cap or roof cap.

• Electrical cable and connectors, sufficient length to

connect the downdraft vent to the remote blower

location. 14-guage min. is recommended, must

conform to local codes.

Parts Supplied

Package

of Screws

8 Hanger

Brackets

2 Adapter

Plates

90°

Elbow

6"

Round

Duct

Blower/

Motor

Control Box

Mounting

Plate

STEP 2 REMOVE THE BLOWER

• Remove the 4 screws holding the blower to the

mounting plate. Retain all screws.

• Lift the blower off the assembly, turn it over to

access the 4 nuts holding the blower to the mounting

plate. Remove the nuts, lift the mounting plate off the

blower.

• Reinstall the mounting plate onto the plenum with

the 4 original screws.

IMPORTANT: Do not lift motor by power cable.

Damage will occur!

Control Box

Loosen

Screw

3"

1234/ 4

Bekijk gratis de handleiding van GE JXRB67, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Gerelateerde producten van GE (Niet gecategoriseerd)

Handleiding bekijken

GE GFC1065

Niet gecategoriseerd - handleiding

Handleiding bekijken

GE Profile PWL1126SS

Niet gecategoriseerd - handleiding

Andere merken in Niet gecategoriseerd