Futurelight WDS-CRMX Duo TX handleiding
Handleiding
Je bekijkt pagina 17 van 20
17
•
EN
OPERATION
Pairing the transmitter and receiver
1 Connect transmitter and receiver to the mains power and switch them on.
Parallel operation: To set up a universe, unlink all devices from previous links. Then only switch on the
receivers that you have designated for this universe. Leave all other receivers switched off temporarily.
2 Shortly press FUNCTION on the transmitter.
The blue LEDs on the transmitter and receiver flash quickly until the wireless connection is established.
Once connected, the LEDs flash slowly without a DMX signal present or permanently with a DMX signal.
The assignment of the receiver to the transmitter is kept memorized even after switching off.
You can assign additional receivers to the transmitter at any time, even during operation. In an operational
system, assigning an additional receiver will make the connected units revert to idle mode for 10 seconds;
they will be reactivated once the new units are connected.
Note
• Some status indications via the LEDs may occur with a short delay.
Disconnecting a receiver from the transmitter
Press FUNCTION on the receiver or transmitter for about 3 seconds.
RX mode: The blue LED goes off and the receiver is unlinked.
TX mode: The blue LED will flash quickly repeatedly; then slowly without a DMX signal present or permanently
with a DMX signal.
Changing the operating mode
The device can operate either as transmitter or as receiver. The operating mode can be changed in two ways.
Method 1 at power up:
1) Press and hold FUNCTION and switch on the device.
2) Release FUNCTION (within 3 seconds).
The device switches the operating mode.
Method 2 during operation:
1) Briefly press FUNCTION 5 times. Then press and hold FUNCTION for at least 3
seconds, until the state of the blue LED changes. The unit enters RX/TX
selection mode.
The blue LED indicates the currently selected mode:
Quick flashing (every 0.2 sec): RX mode
Slow flashing (every 1.0 sec): TX mode
2) Press FUNCTION briefly to change the mode.
3) Press and hold FUNCTION for three seconds to save the setting.
The device switches the operating mode after a short delay.
Bekijk gratis de handleiding van Futurelight WDS-CRMX Duo TX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Futurelight |
| Model | WDS-CRMX Duo TX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2365 MB |