Futurelight WDS-CRMX Duo TX handleiding
Handleiding
Je bekijkt pagina 18 van 20
18
•
EN
Switching the TX protocol
The device can switch the transmission protocol in TX (transmitter) mode. The setting determines which frequency
band is used and if legacy G4 and G3 units can be used in the wireless environment.
1) Unlink any receivers currently connected first.
2) Briefly press FUNCTION 3 times. Then press and hold FUNCTION for at
least 3 seconds, until the RGB LED starts flashing. The unit enters TX
protocol selection mode.
The RGB LED will blink fast in different colors to indicate the currently
selected protocol.
CRMX: R + G + B (white)
G4S: R + B
G3: G
3) Press FUNCTION briefly to change the mode.
4) Press and hold FUNCTION for 3 seconds to save the setting.
The RGB LED shows the new mode with a short delay.
5) Connect the transmitter and receiver(s) as previously described.
CLEANING AND CARE
The outside of the device should be cleaned periodically to remove contaminants such as dust etc.
1 Disconnect the device from power and allow it to cool before cleaning.
2 Clean the surface with a soft lint-free and moistened cloth. Never use alcohol or solvents as these may
damage the surface. Make sure that no liquids can enter the device.
3 The device must be dry before reapplying power.
There are no serviceable parts inside. Do not open the housing. Do not try to repair the device by yourself as this
may result in damage. Maintenance and service operations are only to be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts. Should you have further questions, please contact
your dealer.
Bekijk gratis de handleiding van Futurelight WDS-CRMX Duo TX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Futurelight |
| Model | WDS-CRMX Duo TX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2365 MB |