Furuno SC-33 handleiding
Handleiding
Je bekijkt pagina 19 van 52
2. WIRING
11
Guideline for Connecting
Follow these guidelines when selecting a mounting location.
• Where the cable connectors and CAN bus/NMEA2000 connectors are subjected to moisture or
water spray, waterproof the connectors as shown below.
1. Wrap the connection point with a single layer of vinyl tape.
2. Wrap one layer of self-bonding tape over the vinyl tape.
3. Wrap two layers of vinyl tape over the self-bonding tape.
2.2 NMEA 0183 Network Connection
Optional interface unit IF-NMEASC is required when connecting with NMEA0183 equipment. For
IF-NMEASC, see the Operator’s Manual of the IF-NMEASC.
2.2.1 How to connect the Cable Assembly (FRU-NMEA-NFF-R15/30)
The installation of the other terminal connector and T-connector is not required because the
FRU-NMEA-NFF-R15/30 is the terminal resistance internal cable of 120 ohm.
Securing and waterproofing connections
• Where the cable connectors and CAN bus/NMEA2000 connectors are subjected to moisture or
water spray, waterproof the connectors as shown below.
1. Wrap the connection point with a single layer of vinyl tape.
2. Wrap one layer of self-bonding tape over the vinyl tape.
3. Wrap two layers of vinyl tape over the self-bonding tape.
Waterproof the connectors
T-connector
Wrap connection in self-bonding tape
for waterproofing.
STEP 2
STEP 1
Wrap the self-bonding tape with vinyl tape, covering approx.
50 mm of the connecting cable.
Bind the tape ends with cable cable ties to prevent the tape
from unraveling.
Bekijk gratis de handleiding van Furuno SC-33, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Furuno |
| Model | SC-33 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9007 MB |
