Furuno SC-33 handleiding
Handleiding
Je bekijkt pagina 17 van 52
1. MOUNTING
9
4. Coat the exposed parts of the nuts, bolts and washers with the Adhesive TB5211 (included)
to prevent corrosion.
5. Connect the antenna pig tale connector to the NMEA2000 bus or a cable from the optional
unit, then waterproof the connection. See chapter 2 for the wiring and the waterproofing.
6. Remove the double-sided tape from the optional bird-repellent fixtures, then attach to the
antenna cover. Coat around the bird-repellent fixtures with the Adhesive TB5211 (included).
7. Fix the SC-33 cable to the pipe at suitable intervals with the cable ties (local supply).
Note: Create a loop in the cable close to the SC-33 and tie the loop with a cable tie for main-
tenance work, as shown in the below figure.
Nut2: Fix in place
Nut1: Fasten
Nut1: Fasten
Note:
Fasten the double nuts as
shown in the figure to the
right. Use spanners with a
length of approx. 200 mm.
Note:
Fasten the double nuts as
shown in the figure to the
right. Use spanners with a
length of approx. 200 mm.
Mounting platform
Hex nuts
Bolt
Spring washer
Flat washer
Coat with adhesive.
Antenna baseAntenna base
Create a loop of more than 15 cm in
diameter (approx. twice the length of a
pigtail connector) so that the loop does
not put stress on the pigtail connector.
more
than
15 cm
Bekijk gratis de handleiding van Furuno SC-33, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Furuno |
| Model | SC-33 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9007 MB |
