Furuno SC-33 handleiding

52 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 16 van 52
1. MOUNTING
8
1.3 Mounting Procedure
Note 1: The bird-repellent fixtures (optional supply) can be attached to the antenna cover to pre-
vent birds from landing on the cover. If it is more convenient to attach the bird-repellent fixtures
before securing the antenna unit to the mounting location, do step 6 below before fixing the an-
tenna unit.
Note 2: According to the installation location, connecting the antenna pig tale connector to the
NMEA2000 bus or a cable from an optional unit in advance is easy to fix to the location. Connect
a cable with reference to step 5 beforehand. Then, waterproof the connection.
1. As shown in the figure below, weld a platform (local supply) for which to mount the SC-33. The
thickness of the platform should be 5 mm to 15 mm.
2. Orient the antenna unit to face the bow, referring to the figure above. The antenna should be
installed within ±2.5° of the bowline.
Note 1: Take care not to crush the cabling when mounting the antenna to the platform.
Note 2: Take care not to cover the vent hole on the antenna.
3. Secure the unit to the platform with four sets of M10 hex. nuts, spring washers and flat
washers (all included as installation materials) with 20 ±2 N•m torque.
BOW
200
300
160
Flat washer
5 mm to 15 mm
Spring washer
Hexagonal nut (M10)
Fixing hole (ø11 mm)
160
Positioning the antenna cable
(Stern view)
IndentIndent
CableCable
Rear view
Vent hole
Nut 1
Torque25 N•m
Nut 2
Torque20 N•m
Nut 1&2 (Simultaneous work)
Nut1: Rotate slightly in opposite
direction to 1 .
Nut 2: Fixed in place.
Antenna unit
Platform
Flat washer
Spring
washer
How to fasten double nuts

Bekijk gratis de handleiding van Furuno SC-33, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkFuruno
ModelSC-33
CategorieNiet gecategoriseerd
TaalNederlands
Grootte9007 MB