Furuno PG-500 handleiding
Handleiding
Je bekijkt pagina 20 van 32
3. INSTALLATION
13
3.6 Setting Baud Rate
Set the baud rate of external equipment.
The default setting is 4800 bps.
When connecting with the NAVpilot-500, use
the default setting (4800 bps).
1. Disconnect the power connector from the
sensor.
2. Reattach the connector to the sensor
while pressing the [AUTO] key. The
sensor is powered on, and the current
baud rate is shown by the LEDs.
3. Press the [AUTO] key to change the
baud rate as appropriate.
AUTO TRUE CALB
STATUS
: On
: Off
4800
9600
19200
38400
LED and baud rate
If baud rate could not be set, the STATUS
LED blinks quickly. Try again.
The sensor returns to the normal mode if
there is no operation for three seconds.
Relation baud rate and output interval
Baud rate Output interval Available sentences
4800
25 No output
100
Up to two sentences can
be output.
200
Up to three sentences can
be output.
1000
9600
25
HDT or HDM
100
Up to three sentences can
be output.
200
1000
19200
25
Up to two sentences can
be output.
100
Up to three sentences can
be output.
200
1000
38400
25
100
200
1000
Note: When an error message occurs, the above
sentences may be changed
.
Bekijk gratis de handleiding van Furuno PG-500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Furuno |
| Model | PG-500 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4174 MB |
