Furuno NAVpilot-1000 handleiding
Handleiding
Je bekijkt pagina 22 van 89
1. OPERATION
1-10
*: Not available when [Self Learning] is set to [ON]. Also, these parameters can be ad-
justed from the [Parameter Menu] window. See section 1.6.
1.7.2 How to activate/deactivate a work profile
To activate or deactivate a work profile, do as follows:
1. Open the user menu.
2. Select [Work Profile].
3. Select the work profile name to be activated or deactivated.
4. Select [Use Profile].
5. Select [Use] to activate the work profile. To disable a work profile, select [Not
Used].
6. Close the user menu.
1.7.3 How to select a work profile
To select a work profile, do as follows:
Select a work profile from the user menu
1. Open the user menu.
2. Select [Work Profile].
3. Select [Select: XXX] (XXX: work pro-
file name that is currently selected).
4. Select the appropriate work profile.
5. Close the user menu.
Page 3
[Rudder Start
Position]
Selects the rudder position to start auto steering.
• [Centered]: Auto steering starts when the rudder is centered.
• [Actual]: Auto steering starts from the rudder position when
auto steering is activated. The offset angle from the center is
used as the trim angle.
Note: This menu item is available only when [RRU Sensor
Type] is set to other than [Not Used] (at installation).
[Rudder Offset] Adjusts the offset value for the rudder angle at center position.
[Reset Default
Settings]
Restores the default work profile settings for the work profile
currently being edited.
Menu item Description
Available work profile names appear.
Bekijk gratis de handleiding van Furuno NAVpilot-1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Furuno |
| Model | NAVpilot-1000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9190 MB |
