Frigidaire GCFG3070BF handleiding
Handleiding
Je bekijkt pagina 20 van 60
IMPORTANT
• Completely remove all oven racks and any accessories from
oven cavity to avoid damage to oven racks. If the oven racks
are not removed they may discolor.
• Aluminum foil will melt when exposed to very hot temperatures.
• Do not spray oven cleaners or oven protective coatings in or
around any part of the oven interior. Clean any soil from the
oven frame, the door liner outside the oven door gasket, and
the small area at the front center of the oven bottom. These
areas heat sufficiently to burn soil on. Clean using soap and
water prior to starting Self Clean.
• Remove any excessive spills. Any spills on the oven bottom
should be wiped up and removed before starting a Self Clean
cycle. To clean use hot, soapy water and a cloth. Large spills
can cause heavy smoke or fire when subjected to high
temperatures.
• Do not allow food spills with high sugar or acid content (such as
milk, tomatoes, sauerkraut, fruit juices, or pie fillings) to remain
on the surface, as they may leave a dull spot, even after
cleaning.
• Do not clean the oven door gasket. The woven material in the
gasket is essential for a good seal. Do not rub, damage, or
remove the oven door gasket. This may compromise the
performance of the oven.
• The kitchen area should be well ventilated using an open
window, ventilation fan, or exhaust hood during the first Self
Clean cycle. This will help eliminate the odors typical for Self
Clean.
• Do not attempt to open the oven door when light is flashing.
Allow about 15 seconds for the motorized door latch mechanism
to completely lock or unlock the oven door.
• Wait one hour before opening the oven door.
6.23 Setting Self Clean
Remove all items from the oven, including oven racks. Be sure oven
door is completely closed.
To set the function:
1. Touch Oven Modes and touch Self Clean.
2. Select Self Clean duration: 2, 3 or 4 hours.
3. Press
to start the Self Clean cycle. When the Self Clean cycle is
on, the door will be locked in about 15 seconds and CLEAN will
appear on the display. Do not force the door open as it can damage
the automatic door locking system.
4. When Self Clean is finished, CLEAN message will disappear, and
Hot will appear on the display.
5. Once the oven has cooled down and Hot is no longer displayed,
you can open the oven door.
CAUTION!
Be careful when opening the oven door after the Self Clean cycle.
There is a risk of burns! Stand to the side of the oven when
opening the door to allow hot steam and air to escape.
When the oven interior has completely cooled, wipe away any residue
or powdered ash with a damp cloth or paper towel.
Self Clean with Delayed Start
You can delay start of the Self Clean function (available only for default
3 hours cleaning cycle).
To do this:
1. Press ON/OFF.
2. Touch Oven Modes and touch Delay Start.
3. Touch NEXT.
4. Scroll Oven Modes to Self Clean and touch.
5. Follow the information on the screen to set delay time and Self
Clean duration.
6. Press to start the Self Clean cycle.
If you need to cancel the Self Clean cycle before its end:
• Press OFF.
• If self clean has heated the oven to a high temperature, allow
enough time for the oven to cool.
• If a power failure occurs during a cleaning cycle or if the function is
canceled before the oven was thoroughly cleaned, it may be
necessary to run another Self Clean cycle.
• If the oven temperature was high enough when Self Clean was
interrupted, the oven control may not allow another Self Clean cycle
to be set for up to 4 hours.
6.24 Steam Clean
The Steam Clean feature offers a chemical free and time saving
method to assist in the routine cleaning of small and light soils. For
heavier baked on soils use the Self Clean feature.
Be sure the oven is level and cool before starting Steam Clean. If the
oven temperature is above room temperature, a triple beep will be
heard, and the function will not start. Steam Clean produces best
results when started with a cool oven.
CAUTION!
Do not add bleach, ammonia, oven cleaner, or any other abrasive
household cleaners to the water used for Steam Clean.
Before cleaning any part of the oven, be sure all controls are
turned off and the oven is cool. There is a risk of burns!
To set a Steam Clean cycle:
1. Remove all racks and oven accessories.
2. Scrape or wipe loose debris and grease from the oven bottom.
3. Pour 1 cup of tap water onto the oven bottom. Close oven door.
4. Touch Oven Modes and touch Steam Clean
5. Touch START.
6. The time left for the Steam Clean cycle is shown on the display. Do
not open the door during this time. If door is open while in Steam
Clean, "d-O" will appear on the display after a few minutes.
7. When the Steam Clean cycle is complete, an alert will sound, and
the Off message will show on the display.
8. Press OFF to return display to show the time of day.
9. Carefully open the door when the Steam Clean is finished. Stand to
the side of the oven, hot air will come out from inside the oven.
10. Wipe oven cavity and bottom. Do not clean oven door gasket.
Avoid leaning or resting on the oven door glass while cleaning the
cavity.
Notes:
• Opening the oven door during the Steam Clean cycle prevents the
water from reaching the temperature needed to clean.
• For best results, clean oven immediately after the cycle is complete.
Steam Clean works best for soils on the oven bottom.
• A non-abrasive scouring pad, stainless steel sponge, plastic
scraper, or eraser style cleaning pad (without cleaner) can be used
for difficult soils. Moisten pads with water before use.
• Place a paper towel or cloth in front of the oven to capture any water
that may spill while wiping out.
• Do not leave the residual water in the oven for any length of time.
• Some condensation or water vapor may appear close to the oven
vent and the oven door glass. This is normal. The oven gasket may
become damp, do not wipe them dry.
• Local water sources often contain minerals (hard water). If hard
water deposits occur, wipe cavity with a 50/50 solution of water and
vinegar or 50/50 solution of water and lemon juice.
• Steam Clean cannot be programmed with a Delay Start feature.
• If the Steam Clean results are not satisfactory, run a Self Clean
feature.
20 ENGLISH
Bekijk gratis de handleiding van Frigidaire GCFG3070BF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Frigidaire |
| Model | GCFG3070BF |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 8305 MB |
