Friedrich ZoneAire Select PZH07K3SB handleiding

Airco

Friedrich

37 pagina's

PDF beschikbaar

Handleiding

C. INSTALLATION OF THE UNIT

Figure C.4.1 (Internal Drain Kit)

PXDR10

QUANTITY DESCRIPTION

COVER PLATES

MOUNTING PLATE

DRAIN TUBE

MOUNTING PLATE GASKET

#10 X ½” SHEET METAL SCREWS

#10-24 X ½ ” MACH. SCREWS

#10-24 X ½" LOCKNUTS

C.4 Install Unit

C.4.1 Install Internal Drain Kit (If applicable)

1. The PXDR10 Drain Kit if applicable, must be installed before the

wall sleeve is installed into the wall.

NOTE: Determine whether drain will be located within the wall, on

the indoor side, or will drain to the exterior of the building. Follow

appropriate instructions below depending on your particular type of

installation.

Internal Drain

NOTE: If installing an internal drain, you MUST install a drain kit on

the wall sleeve before the wall sleeve is installed.

1. Locate the drain within the “Preferred” area of best drainage.

Maintain at least a ½” clearance from the embossed area.

2. Using the mounting plate with the ½” hole as a template, mark

and drill two, 3/16” mounting holes and a ½” drain hole in the

sleeve bottom.

3. Remove the backing from the gasket and mount it on the ﬂat

side of the mounting plate. (See Figure C.4.2). Insert the

drain tube through the hole in the gasket and mounting plate

so the tube ﬂange will be against the wall sleeve.

4. Position the assembly beneath the drilled holes and secure it

with #10-24 x ½” machine screws and lock nuts provided. Seal

the tops of the screws with silicone caulking.

5. Use ½” I.D. copper tube, PVC pipe, or vinyl hose (obtained

locally) to connect the internal drain tube to the drain system

in the building.

6. Referring to C.4.2 locate and assemble the (2) two cover plates and

gaskets over the drain holes at the rear of the wall sleeve. Attach

them with the #10 sheet metal screws provided. Make certain that the

four overﬂow slots at the rear of the wall sleeve are not blocked (See

drawing of the back of the sleeve Figure C.4.2).

7. If a deep wall extension (PDXWSEXT) is used, after installing

the ﬁeld supplied ﬂashing, caulk as required. Be sure to caulk

around the ﬂashing and the wall sleeve where the hole was

drilled for the drain tube.

DRAIN TUBE

SIDE VIEW

FRONT VIEW

WALL SLEEVE

OPTIONAL AREA

PREFERRED AREA-

NO FOAM INSULATION

NOTE: IF THE DRAIN MUST BE

LOCATED IN THE OPTIONAL

AREA, THE FOAM INSULATION

MUST BE CUT AWAY AND

REMOVED TO ALLOW ACCESS

TO THE DRAIN.

NUT

MOUNTING

PLATE

GASKET

SCREW

OPTIONAL

AREA MUST BE 18”-21” CENTERED

FROM SIDEW

ALLS TO ENSURE DRAINAGE

Bekijk gratis de handleiding van Friedrich ZoneAire Select PZH07K3SB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.