Festool Cleantec CTL 36 AC PLANEX handleiding

Stofzuiger

Festool

117 pagina's

PDF beschikbaar

Handleiding

The connection display[1-6] flashes slowly.

For a period of 60seconds, the mobile dust

extractor is ready for connection.

► Turn on the battery-powered power tool.

The mobile dust extractor starts up and the

battery-powered power tool is connected

until the mobile dust extractor is manually

switched off or the mains plug is disconnec

ted. The cordless tool must then be connec

ted again.

Connecting a new battery-powered power tool

overwrites the previous connection.

7.2 Connecting the CT-F I remote control

Connecting the remote control and the mobile

dust extractor

To be able to connect a remote control to a

mobile dust extractor, the remote control must

be reset (see "Resetting the remote control").

A remote control that has not been connected

previously can be connected directly.

A connection that has been established

between the remote control and the mo

bile dust extractor will persist even after

the mobile dust extractor has been man

ually switched off or the mains plug has

been disconnected.

► Hold down the connection button[1-7] on

the mobile dust extractor for three seconds

in standby mode.

The connection display[1-6] flashes rapid

ly.

For a period of 60seconds, the mobile dust

extractor is ready for connection.

► Press the MAN button on the remote con

trol.

The remote control is permanently stored in

the mobile dust extractor.

Switching on/off

Once the remote control is connected to the

mobile dust extractor, the mobile dust extractor

can be switched on and off with the remote con

trol.

► Press the MAN button on the remote con

trol to switch the device on and off.

Resetting on the remote control

Resetting deletes the connection between a re

mote control and the mobile dust extractor.

► Hold down the connection button and the

MAN button for tenseconds.

☑ The LED indicator lights up purple if the

reset has taken place.

7.3 Festoolapp*

The mobile dust extractor can be configured

with the Festoolapp.

► Hold down the connection button[1-7] on

the mobile dust extractor for threeseconds

in standby mode.

The connection display[1-6] flashes rapid

ly.

For a period of 60seconds, the mobile dust

extractor is ready for connection.

► Follow the instructions provided in the

Festoolapp.

*Not available in all countries.

8 Settings

8.1 Adjusting the suction power

► Press the plus or minus button[1-11] while

extracting.

8.2 Connecting sleeve

The bypass function of the connecting

sleeve prevents strong suction from sanding

machines and floor nozzles on smooth surfa

ces.

Open

► Turn the adjusting ring to the "OPEN" posi

tion.

► Turn the adjusting ring to the "CLOSE" posi

tion.

8.3 Applying the brake

Folding out the black brake lever[1-17] pre

vents the mobile dust extractor from rolling. To

achieve this, lift the front end of the mobile dust

extractor slightly and push the black brake lev

er downwards until it latches into place. Press

the release button[1-16] to release it.

8.4 Temperature cut-out

A temperature cut-out switches the mobile dust

extractor off when it reaches a critical tem

perature to prevent overheating. The bottom

LED indicates a fault.

LED lights up red Excessive temperature

► Switch off the mobile dust extractor, let it

cool down.

► Switch on the mobile dust extractor again

after approx. five minutes.

English

Bekijk gratis de handleiding van Festool Cleantec CTL 36 AC PLANEX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.