Extron TLI Pro 201 handleiding
Handleiding
Je bekijkt pagina 24 van 48
TLI Pro 201 • On-screen Menus 16
Sleep Timer
The Sleep Timer determines how long the panel is inactive before it enters sleep mode (see NOTES below).
To deactivate the sleep timer, set the switch to Off. While the sleep timer is deactivated, the controls for the sleep
timer are unavailable. To activate the sleep timer, set the switch to On.
Press the + or - buttons to set the time (in minutes). The timer range is from 1 to 120 minutes.
Display Timer
The Display Timer determines how long the panel is inactive before the video sync is disconnected.
To deactivate the display timer, set the switch to Off. While the display timer is deactivated, the controls for the
display timer are unavailable. To activate the display timer, set the switch to On.
Press the + or - buttons to set the time (in minutes). The timer range is from 1 to 120 minutes.
NOTES:
• When the Sleep Timer is used to deactivate the screen, the TLI Pro 201 outputs a black screen, which
provides partial energy savings. The screen reactivates quickly when it is touched.
• When the Display Timer is used to deactivate the screen, the screen switches off, which provides better
energy savings but the screen takes longer to reactivate when it is touched.
• When the Display Timer expires, some 3rd-party touch displays cut power to the USB ports when the
video sync is cut. If this occurs, press the MENU button on the TLI Pro 201 (see figure 5,
C
, on
page 10) or disconnect and reconnect the USB cable (see figure 2,
C
, on page 5).
Input
Touchpanel Setup
EXIT
STATUS
NETWORK
OUTPUT
INPUT
AUDIO
PROJECT INFORMATION
ADVANCED
Input
Connected Display
HDMI
LPCM 2Ch
SGT
3840x2160 at 30Hz
Output Config
HDMI
LPCM 2Ch
SGT
1080p at 30Hz
Input Status
HDMI
LPCM 2Ch
HDCP
1080p at 60Hz
HDMI
LPCM 2Ch
1080p at 30Hz
Signal
EDID
Input Configuration
FOLLOWFILL
Aspect Ratio
HDCP Authorize
EDID Minder
Video Preview
Touchpanel Setup
EXIT
STATUS
NETWORK
OUTPUT
INPUT
AUDIO
PROJECT INFORMATION
ADVANCED
Input
Figure 14. Input Screen
At the top of the screen the resolution and refresh rate of the connected display and the current output
configuration are shown. These are read-only.
Input Status
The Input Status panel is read-only. The Signal section shows the resolution and refresh rate of the incoming
HDMI signal.
The EDID section displays the current EDID applied to the TLI Pro 201 HDMI input. For best results, the
resolution and refresh rates in the EDID section should match those in the Signal section.
Bekijk gratis de handleiding van Extron TLI Pro 201, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | TLI Pro 201 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6183 MB |
