Extron NBP VC1 D handleiding
Handleiding
Je bekijkt pagina 30 van 73
Network Button Panels • Hardware Features and Installation — Wall-mountable Models 20
Instructions for US Gang Models
The faceplate, button labels, and knob can easily be changed at any time. Some button labels ship with the unit.
You can create and print your own customized labels using Extron Button Label Generator software, which is
available in the software Download Center page on the Extron website.
Removing and replacing a faceplate
To replace a faceplate:
1. Remove the faceplate by holding the body of the unit with one hand, gripping the sides of the faceplate with
the other hand, and pulling the faceplate away from the unit.
2. Align the openings of the new faceplate with the buttons and knob and with the LEDs and place the faceplate
against the unit. The magnetic catches fasten the faceplate onto the unit.
TIP: You can wait until the unit is mounted to the junction box or mud ring before placing the new
faceplate on the unit.
Replacing button labels
To change a button label:
1. Remove the faceplate (see step 1 of “Removing and replacing a faceplate”, above).
2. For each button label to be replaced, gently separate the button lens cap from its
white diuser. To do this, insert the end of the provided Extron removal (pry)
tool into the corner notch and gently twist the tool
(see gure 23,
1
).
3. Remove the label insert from the translucent button cap.
4. Select one of the button labels from the printed label
sheets included with the unit. Remove the label from its
backing and remove the clear, protective lm from the
front of the label.
5. Insert the button label into the button cap (see
2
).
Check for correct label orientation.
6. Align the cap with the white diuser and the panel
opening, and press the clear cap into place on the
button.
7. Reattach the faceplate to the unit (see step 2 in
“Removing and replacing a faceplate”, above).
Changing a knob
To change a knob:
1. Remove the faceplate as described in step 1 of
“Removing and replacing a faceplate”, above.
2. Firmly grasp the knob and pull it away from the NBP.
3. Align the ridge inside the new knob with the channel on the knob control and allow the magnet in the knob to
snap into place.
4. Reattach the faceplate to the unit (see step 2 in “Removing and replacing a faceplate”).
Rev. D: Added a reference and link
to the Download Center page per
Aurelio Valencia’s request.
TEXT
Separate the
two-piece button
here at the corner.
Diffuser
Base
Insert
button label.
Button
Lens Cap
Removal
Tool
1
2
Figure 23. Replacing Button Labels on
a US Gang Model NBP
23
Bekijk gratis de handleiding van Extron NBP VC1 D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | NBP VC1 D |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12926 MB |
