Extron NBP VC1 D handleiding
Handleiding
Je bekijkt pagina 27 van 73
Network Button Panels • Hardware Features and Installation — Wall-mountable Models 17
4. Remove any buttons to be replaced as follows:
a. Press the button or button pair from the front of the
faceplate out through the back of its opening. If
necessary, pull the buttons out gently from the back.
NOTE: The smaller buttons are arranged in pairs
connected by a rubbery membrane.
b. If you are replacing the faceplate, repeat step 4a until
all buttons are removed.
c. Set the removed buttons aside for later use.
5. Insert a button or button pair as follows:
a. Insert a new button or button pair from the back into
the appropriate opening in the faceplate.
b. Align the two pegs in the upper left and lower right
corners of the button or button pair (as shown at right)
with the corresponding holes in the faceplate. Press the
button or buttons into the faceplate so the buttons and
pegs are seated into the holes and faceplate opening.
c. Repeat steps 5a and 5b for any additional buttons to be
replaced or installed.
Figure 17. Removing Buttons From an
EU Faceplate.
Rev. G:
Added EU
model.
17
OFF
ON
Pegs (2)
Figure 18. Inserting Buttons (Decorator-
style model shown)
18
Bekijk gratis de handleiding van Extron NBP VC1 D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | NBP VC1 D |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12926 MB |
