Extron FOX3 SR 301 handleiding
Handleiding
Je bekijkt pagina 21 van 58
FOX3SR 301 and FOX3SR311 Scaling Receivers • Operation 13
• USB 2.0 Host LED — When the transmitter and receiver are connected through
the SFP port and a USB 2.0 Host device is connected to the transmitter, the LED
remains lit to indicate an active connected device.
• USB 2.0 1 LED — When the transmitter and receiver are connected through the
SFP port and a USB 2.0 Host device is connected to the transmitter, the LED
remains lit to indicate an active connected device.
E
MENU and ENTER buttons (see figure9 on page12)— Press these buttons to
access and navigate the on-screen display menu system.
F
Navigation buttons — Press these buttons to navigate through the on-screen display
menu system or change settings.
Operations
After the transmitter, receiver, and the connected devices are powered up, the system is fully
operational. If any problems are encountered, ensure all cables are routed and connected
properly.
NOTE: Ensure that the video source and display are properly connected to the FOX3
transmitter and scaling receiver, and power is applied to the FOX3 transmitter and
scaling receiver and the display before power is applied to the video source. If the
other devices are not turned on before the video source, the image may not appear.
Configuration and operation of the system is accomplished via SIS Configuration and
Control (see page21), the Internal Web Page (see page41), and Configuration
Software (see page32).
Using the On-Screen Menu System
The OSD menus are used primarily for the initial setup of the device. The on-screen menu
presents configuration options on a local monitor and can be adjusted with front panel
controls.
NOTE: The on-screen menu has a default timeout of 60 seconds.
Menu Selection Buttons
• MENU button — Press the MENU button (see figure10,
1
) to activate or exit the on-screen menu, deselect a
submenu, or cancel a pending change.
• ENTER button — Press the ENTER button (
2
)
to access the on-screen menu, select submenus,
submenu items, or to accept pending changes.
• Navigation buttons — Press these buttons to
navigate through the menu system:
FOX3 SR 301
CONFIG
INPUTS
SIGNAL
HDCP
USB HID
USB 2.0
USB
1 2
MENU
ENTER
HOST
F
2
2
2
1
1
1
3
3
3
5
5
5
4
4
4
6
6
6
Figure 10. Menu Selection
Buttons
• Press the (Up) (
3
) or the (Down) (
4
) arrow button to navigate submenus or
submenu items.
• Press the (Left) arrow button (
5
) to exit currently selected submenus or
submenu items.
• Press the (Right) arrow button (
6
) to access currently selected submenus or
submenu items.
Also use the navigation buttons to adjust settings according to specific setting directions.
10
Bekijk gratis de handleiding van Extron FOX3 SR 301, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | FOX3 SR 301 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10927 MB |
