Extron DTP T USW 333 handleiding
Handleiding
Je bekijkt pagina 16 van 41
DTP T USW 333 • Installation and Operation 8
Connector and Cable Details
VGA connector wiring
The 15-pin HD (VGA) universal analog input ports accept RGB video (RGBHV, RGBS, RGsB). Figure 3 shows
the pinouts for each format type on the connector.
Pin RGBHV
1
Red
Green
Red return
Green return
Blue return
NC
Blue
RGBS/RGsB
2
Red
Green
NC
6 Red return
7 Green return
8 Blue return
3 Blue
15
11
15
4, 5
Pin RGBHV RGBS/RGsB
9
10
14
15
11
12
13
NC
Ground
V sync
NC
H sync
NC
Ground
NC
NC
NC NC
C sync
NC NC
Figure 3. VGA Connector Wiring
HDMI connector
HDMI signals run at a very high frequency and are especially prone to errors caused by bad video connections,
too many adapters, or excessive cable length. To avoid the loss of an image or jitter, follow these guidelines:
• Do not exceed 16.4 feet (5 meters) on the input of the transmitter or the output of the connected receiver.
• Use only the cable designed for HDMI signals that is supplied by Extron.
• Limit or avoid the use of adapters.
• Use only cables specifically intended for HDMI or DVI signals. Use of non-HDMI or non-DVI cables or
modified cables can result in a missing video output.
To securely fasten an HDMI cable to a device:
1. Plug the HDMI cable into the panel connection (see
figure 4,
1
).
2. Loosen the HDMI connection mounting screw from the
panel enough to allow the LockIt lacing bracket to be
placed over it (
2
). The screw does not have to be
removed.
3. Place the LockIt lacing bracket on the screw and
against the HDMI connector, then tighten the screw to
secure the bracket (
3
).
11
33
22
55
44
Figure 4. Installing the LockIt Lacing Bracket
ATTENTION:
• Do not overtighten the HDMI connector mounting screw. The shield to which it fastens is very thin
and can easily be stripped.
• Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel elle est attachée
est très fin et peut facilement être dénudé.
4. Loosely place the included tie wrap around the HDMI connector and the LockIt lacing bracket as shown (
4
).
5. While holding the connector securely against the lacing bracket, use pliers or similar tools to tighten the tie
wrap, then remove any excess length (
5
).
3
4
Bekijk gratis de handleiding van Extron DTP T USW 333, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | DTP T USW 333 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7629 MB |
