Evolis signoSign/2 handleiding
Handleiding
Je bekijkt pagina 18 van 73
© signotec GmbH 2000-2024
signoSign/2 Documentation
Rev. B
Page 18 of 73
Use the Sampling rate drop-down list to adjust the signature quality. You can choose
between the values 125 Hz – Low bandwidth requirement, 250 Hz – Default value and
500 Hz – Very precise sampling. The higher this value, the higher the quality of the
signature. However, please keep in mind that this may cause the data volume to increase,
which may affect your network performance depending on the connection type, as well as
the file size of the signed document. The option ‘250 Hz – Default value’ is selected by
default.
This setting always relates to the type of signature device. Assuming two signotec Sigma
signature pads are connected, it is not possible to set a sampling rate of 125 Hz for the first
signature pad and a sampling rate of 250 Hz for the second signature pad. In such a case,
the setting applies for both devices and is adjusted synchronously in both settings dialog
boxes. If two different types of signature device are connected, for example a Sigma and
an Omega, the setting applies only for the corresponding device type. The settings are
saved permanently and used for any new connected signature pads of the same type.
You can use Replace standby image to configure a graphic that will be loaded into the
configured (first and second signature device) signature pad when signoSign/2 is closed, if
the graphic saved there differs from the one in signoSign/2. You can use the check box to
activate and deactivate this option. Click the button with the three dots to access the
‘Choose image...’ dialog where you can select a graphic in the format .bmp, .jpg, .gif or
.png. Alternatively, you can enter the path for the graphic and edit it directly in the input
field. Please make sure that the graphic is the right size (see table below) as graphics of
different sizes are not scaled.
Signature pad
Size
Sigma
320 x 160 px
Omega
640 x 480 px
Gamma
800 x 480 px
Delta
1280 x 800 px
Zeta
320 x 200 px
The signature pad signotec Sigma Lite uses the setting of the signotec
Sigma. However, this setting is ignored for the signotec Sigma Lite as it
does not contain a display.
Clicking the button with the arrow transfers the configured graphic directly to the
signature pad and you don’t have to wait for signoSign/2 to close.
This setting also always relates to the type of signature device, but manual transfer is only
ever performed for the signature pad for which you have called up the configuration.
Display a preview of the document in the signature device during signing
The preview settings are available for the signature pads signotec Omega, Alpha, Gamma
and Delta, but not for the signotec Sigma, Sigma Lite and Zeta.
You can display an excerpt of the document on the signature pad while a signature field is
being signed.
This preview option cannot be configured for the signotec Alpha as DIN A4
Portrait documents are already shown in full because of the size of the
display.
The horizontal and vertical spacing is entered as a percentage and it defines the Spacings
between the signature field and the edge of the document. This makes it possible to
determine the position of the signature field within the excerpt. Use the sliding scale
beneath the sample excerpt to set the magnification level. A Size of 100% means that the
Bekijk gratis de handleiding van Evolis signoSign/2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Evolis |
| Model | signoSign/2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8452 MB |