EtherWAN EDGE 2 handleiding
Handleiding
Je bekijkt pagina 15 van 71
EDGe 2
15
Internal View
After removing the top cover, you can see all the available hardware connectors.
Note:
1. By default S1 (Power Switch) is in OFF state, and J6 (Power Source) is in BAT state, EXT is not supported.
2. Before proceed to the following hardware configuration details, be sure to keep S1 at OFF state till the
moment you finish the required configuration and need to power up the device.
3. The RESET button provides a quick way to reboot the device.
S1:
Power Switch
(ON/OFF)
J6:
Power Source
Jumper
S2:
RESET
Button
S3:
DIP switch for
optional conf.
CON1:
2x6 headers for
device
configuration
CON2:
8-pin spring-type terminal block for
RS485, ext. power, wake-up trigger
CON3:
Battery power
socket
CON4:
2x3 headers for AIs.
w/o Jumper: 0-10V
/w Jumper: 4-20mA
CON5:
16-pin spring-type
terminal block for I/Os
Battery stand
Nano-SIM
Socket
Status LEDs
Antenna
Cable
Bekijk gratis de handleiding van EtherWAN EDGE 2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | EtherWAN |
| Model | EDGE 2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18648 MB |
