Elsner Corlo Touch KNX handleiding
Handleiding
Je bekijkt pagina 142 van 148
140 Additional settings (ETS)
Display Corlo Touch KNX • Status: 30.08.2021 • Technical changes and errors reserved.
Long holding (release after Time 1+2 runs out): Drive moves independently to the end
position. The movement can be interrupted by a short tap.
Dead man's switch:
The drive moves as soon as the button is actuated and stops as soon as the button is
released.
6.2. Temperature threshold values
The Display Corlo Touch KNX can evaluate the temperature readings (e. g. from a
T-NTC at an input) using the temperature threshold values and then activate output
objects accordingly.
ETS: Temperature thresholds
Activate the necessary temperature threshold values.
Point in time 0: Actuate of button, start of time 1
Release before time 1 expired: step (or stop if drive is moving)
Point in time 1: End of time 1, start of time 2
Moving command
Release after time 1 expired
but before time 2 expires: Stop
Release after time 1 + 2 expired: Move into end position
Control mode Comfort mode
Behavior during button operation:
Button is pushed and
released before time 1 expired = stop/step
held longer than time 1 = Up or Down
released between time 1 and 1-2= stop
released after time 1 +2 = no more stop
Time 1 0.0s ... • 2 s; 0.4 s
Time 2 0 s • 2 s; 2 s
Control mode Dead man's switch
Behavior during button operation:
Push button = Up or Down command
Release button = Stop command
Use threshold values 1 - 4 No • Yes
Time 1 Time 2
01 1 + 2
Fig. 10
Time interval comfort mode diagram
Bekijk gratis de handleiding van Elsner Corlo Touch KNX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elsner |
| Model | Corlo Touch KNX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16939 MB |
