Elsner Corlo Touch KNX handleiding
Handleiding
Je bekijkt pagina 141 van 148
139 Additional settings (ETS)
Display Corlo Touch KNX • Status: 30.08.2021 • Technical changes and errors reserved.
Control modes for drive control
Behaviour on button actuation in standard control mode:
Standard:
If briefly operated, the drive will move incrementally or stops. If operated longer, the
drive will move up to the end position. The time difference between "short" and "long"
is set individually.
Standard inverted:
When pushed shortly, the drive moves up to the end position. When pushed for longer,
the drive moves incrementally or stops. The time difference between "short" and
"long" and the repeat interval is set individually.
Comfort mode:
In the comfort mode actuating the button briefly, a bit longer and long will trigger
different responses of the drive. The time intervals are set individually.
Short actuation (shorter than Time 1): The drive is positioned step-wise and stopped.
Holding it slightly longer (longer than Time 1, but shorter than Time 1+2): Drive
running. Drive stops when the button is released.
On change of
if transmitted on change
0.1°C • ... • 0.5°C • ... • 5.0°C
Transmission cycle
if transmitted periodically
5 s...2 h
Short: Press and hold:
Shutter Stop/step Up or Down
Blind Stop Up or Down
Awning Stop Retract or Extend
Window Stop Close or Open
Control mode Standard
Behavior during button operation:
short = stop/increment long = Up or Down
Time between short and long
in 0.1 seconds
1...50; 10
Control mode Standard inverted
Behavior during button operation:
short = Up or Down long = Stop/Step
Time between short and long
in 0.1 seconds
1...50; 10
Repeat the step command
for a long button press
every 0.1 s • every 2 sec; every 0.5 sec
Bekijk gratis de handleiding van Elsner Corlo Touch KNX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elsner |
| Model | Corlo Touch KNX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16939 MB |
