Elsner Corlo Touch KNX 5in WL Handleiding (144 Pagina's)

Handleiding

16 Description

Display Corlo Touch KNX 5in • Status: 30.08.2021 • Technical changes and errors reserved.

1.4.1. WLAN settings in the ETS

The WLAN connection must be set up in the ETS. Consult the WLAN setting section in

the manual

ETS: System Settings > WLAN

 2.13.1 WLAN

You set the network name and the encryption for compatibility with the WLAN network

access point. The IP address allocation can be made either automatically by DHCP or

manually.

Please note: If an automatic change depending on the quality of the connection bet-

ween 2.4/5 Ghz should be possible, you have to set up in the wireless router the same

Wi-Fi name with the same Wi-Fi password for both frequencies. Otherwise, only the

frequency defined with the access can be used. (From version OPSys 0.1.4 or higher)

1.4.2. Displaying WLAN status on the display

You can call up information on the current status of the connection on the Corlo

Touch KNX 5in WL display. Network name, signal strength, IP address, DNS address

and GW address are displayed.

 Settings > System > Service > WLAN Status

 3.11.7. WLAN Status

1.5. Maintenance and care

Fingerprints on the glass area and frame are best removed with a cloth moistened with

water or a microfiber cloth. Do not use an abrasive cleaning agent or aggressive clean-

sing agents.

For cleaning of the screen, the „cleaning mode“ can be used, that is activeted via the

display.

 Settings > Cleaning Mode

During a period set in the ETS, the touch function is disabled then and the screen can

be cleaned.

Bekijk gratis de handleiding van Elsner Corlo Touch KNX 5in WL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.