Eliminator Lighting Elektron Bar FX handleiding

Niet gecategoriseerd

Eliminator Lighting

29 pagina's

PDF beschikbaar

Handleiding

DMX SETUP

Special Note: Line Termination. When longer runs of cable are used, you may need to use a terminator

on the last unit to avoid erratic behavior. A terminator is a 110-120 ohm 1/4 watt resistor which is con-

nected between pins 2 and 3 of a male XLR connector (DATA + and DATA -). This unit is inserted in the

female XLR connector of the last unit in your daisy chain to terminate the line. Using a cable terminator

(ADJ part number Z-DMX/T) will decrease the possibilities of erratic behavior.

5-Pin XLR DMX Connectors: Some manufacturers use 5-pin DMX-512 data cables for DATA trans-

mission in place of 3-pin. 5-pin DMX xtures may be integrated into a 3-pin DMX line with a 5-pin to

3-pin adapter cable. These adapters are readily available at most electronics stores. Follow the chart

below for a proper conversion.

Notice: Be sure to the gures below when making your own cables. Do not use the ground lug on

the XLR connector. Do not connect the cable’s shield conductor to the ground lug or allow the shield

conductor to come in contact with the XLR’s outer casing. Grounding the shield could cause a short

circuit and erratic behavior.

Bekijk gratis de handleiding van Eliminator Lighting Elektron Bar FX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.