Eliminator Lighting Elektron Bar FX handleiding

Niet gecategoriseerd

Eliminator Lighting

29 pagina's

PDF beschikbaar

Handleiding

DMX SETUP

DMX Addressing:

All xtures should be given a DMX starting address when using a DMX controller, in order to ensure

that the correct xture responds to the correct control signal. This digital starting address is the channel

number from which the xture starts to “listen” to the digital control signal sent out from the DMX

controller. The assignment of this starting DMX address is achieved by setting the correct DMX address

on the digital control display on the xture.

You can set the same starting address for all xtures or a group of xtures, or set different addresses for

each individual xture. Setting all xtures to the same DMX address will cause all xtures to react in the

same way; in other words, changing the settings of one channel will affect all the xtures simultaneously.

If you set each xture to a different DMX address, each unit will start to “listen” to the channel number

you have set, based on the quantity of DMX channels of each xture. That means changing the settings

of one channel will only affect the selected xture. For instance, when this unit is set to 4 Channel

mode, you should set the starting DMX address of the rst unit to 1, the second unit to 5 (1 + 4), the

third unit to 9 (1 + 4 + 4), etc...

Channel Mode Unit 1 Address Unit 2 Address Unit 3 Address Unit 4 Address

4Ch 1 5 9 13

13Ch 1 14 27 40

209Ch 1 210 419 628

Bekijk gratis de handleiding van Eliminator Lighting Elektron Bar FX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.