Eizo ColorEdge ColorNavigator 7 handleiding

Niet gecategoriseerd

Eizo

99 pagina's

PDF beschikbaar

Handleiding

Chapter 3 Basic Usage

Target name

Enter a target name. To change the target name, edit the target name displayed in the text box.

Color mode name

To change the color mode name with its target congured, select the checkbox and enter a new color

mode name you want to specify.

Target value

Set a value of each item.

Note

• Depending on the monitor you use, the displayed items and selectable items are di󰀨erent.

Item Description of the settings

Preset target Select a preset target from the pull-down menu.

Brightness Specify the target brightness. When using the slider to specify a value,

select “Standard Input”. To enter a value directly, select “Manual”. Selecting

“Maximum” or “Minimum” will set the target values to the maximum or minimum

brightness of the current monitor.

Black level Specify the brightness of black color for the monitor. Set the value by using

either the minimum brightness value of the monitor or manually entering the

brightness value.

If the contrast is too high, increasing the black level can reduce the contrast.

White point Specify the white point. Select “Standard value”, “Color temperature”, or

“Coordinate” for the setting method, and then specify a value.

Gamma (EOTF) Set a gamma value. Select a setting method from the following options and set

the value.

• Set the value from the standard value to be referenced

• Set the gamma value using the slider or input a value manually

• Specify the L*gamma value

• Specify the gamma value by loading the LUT le

Note

• The following describes LUT les that are loadable:

- Data format is CSV

- Values are 256 or 1024

- Values are integer or fractional values equal to or above 0 and increases

upward

Priority Select a gamma priority from the following options.

• Standard (Color tones are adjusted for the middle tone only and no

adjustment is made for the low tone)

• Gray balance (Color tones including the low tone are adjusted)

• Fixed gamma (Colors are displayed in the status congured by the gamma

(EOTF) settings and no color tone adjustment is made)

Attention

• “Gray balance” cannot be adjusted if the following measurement devices are

used:

- CG2420’s and CG2730’s built-in calibration sensors

- EIZO EX3, EX4, EX5

- Datacolor Spyder5, SpyderX, SpyderX2, SpyderPro, Spyder

Bekijk gratis de handleiding van Eizo ColorEdge ColorNavigator 7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.