Eizo ColorEdge ColorNavigator 7 Handleiding (99 Pagina's)

Handleiding

11

Chapter 2 Setup

2-2. Connecting the USB Cable

1.

Use the provided USB cable (MD-C93 or UU200SS) to connect the USB Type-B

connector (upstream) of the monitor to the USB Type-A connector (downstream)

of the computer.

Attention

• If your computer does not have a Type-A connector but has a Thunderbolt

TM

3 or USB Type-C connector, add

a commercially available USB Type-C to Type-A conversion adapter.

• Under default setting, Connector 1 is enabled when a monitor with two USB Type-B connectors (upstream) is

used. Connect the USB cable to the connector indicated as “1”.

• Do not remove the USB cable while ColorNavigator 7 is operating. Doing so may result in system freeze or

software malfunction.

Note

• If you use a USB Type-C cable to connect your monitor with the computer, this step is not necessary.

2.

If you use an external measurement device, make sure that the measurement

device is connected to the USB Type-A connector (downstream) of your

computer or monitor.

Attention

• Depending on the measurement device, limitations may apply to the connected USB port. For more

information about connecting measurement devices, refer to the user’s manual of the measurement device.

• Do not remove the measurement device from the USB port while ColorNavigator 7 is operating. Doing so may

result in system freeze or software malfunction.

Note

• If you use the built-in calibration sensor, there is no need to connect an external measurement device.

• By installing ColorNavigator 7, the drivers for the corresponding measurement devices are also installed at

the same time. There is no need to install the driver provided with the measurement device (for Windows

only).

Bekijk gratis de handleiding van Eizo ColorEdge ColorNavigator 7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.