Eibenstock EPO 200-3 R NT handleiding
Handleiding
Je bekijkt pagina 16 van 64
16
During use, the operator and other persons standing nearby have
to wear suitable ear protectors, a dust mask and protection
goggles.
Make sure that persons in the work space are not endangered by
Particles flying around.
Always hold the machine with both hands.
Attention! The tool still runs for a little while after the machine was
switched off.
For further safety instructions please refer to the enclosure!
Before starting the machine check the correspondence between voltage
and frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed.
For protection purposes the EPO 200-3 R NT can only be run with a GFCI.
The machine is standard equipped with a PRCD protective switch
integrated in the cord.
!
Attention!
The PRCD protective switch must not lay in water.
PRCD protective switches must not be used to switch
the tool on and off.
Before starting your work, check the proper function
by pressing the TEST button.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
Cross section in sq. mm
1.5
2.5
110V
20 m
40 m
230V
50 m
80 m
The tool is equipped with a start-up speed limiter to prevent that swift
automatic circuit breakers are unintentionally triggered.
Electrical Connection
Bekijk gratis de handleiding van Eibenstock EPO 200-3 R NT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | EPO 200-3 R NT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6520 MB |
