Eibenstock BST 352 V handleiding
Handleiding
Je bekijkt pagina 16 van 112
16
▪ Secure the washer (E) and finally the
fastening nut (F) on the quick-release
screw (D).
▪ Tighten the nut (F) with a 27 mm
wrench.
▪ Before and after tightening the nut (F),
adjust the 4 adjustment screws as ne-
cessary to adapt to the surface.
Be sure to check that the stand is
securely mounted.
Vacuum attachment to the floor
Do not use the vacuum attachment on walls or overhead!
For vacuum mounting, the surface to be drilled must not be porous and must
be flat and free of cracks.
If this is not the case, this type of mounting cannot be used. For vacuum
mounting, you will need a vacuum pump, the vacuum hose and the vacuum
set BST 352 V (see fig.). These are available on request.
Assembling the vacuum set:
Position the connection plate of the vacuum set
on the drill stand base as shown.
Turn the switch knob to lock the connection plate
in the base.
Check that the connection plate is correctly sea-
ted.
Place the foam rubber seal in the groove on the
underside of the base.
Bekijk gratis de handleiding van Eibenstock BST 352 V, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | BST 352 V |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 20311 MB |
