Ecler VEO-XTI2L handleiding
Handleiding
Je bekijkt pagina 32 van 85
32
In order to change parameters, such as the IP address, host ID, casting mode or Ip mode,
just select the device you want to configure and enter the required data. This page also
allows you to perform a device reset or a factory reset from the remote control of the
selected device.
You must click "Apply" after making changes.
10.2 Configuring the Casting mode using the Control Centre
To put together a video wall, the transmitters and receivers must be configured with the
same IP multicast (group ID).
In the multipoint-to-multipoint, matrix and video wall configurations, the transmitters
and receivers must be configured in multicast mode. You need to change the casting
mode from unicast to multicast, as shown below, and click "Apply" to confirm the new
configuration.
Bekijk gratis de handleiding van Ecler VEO-XTI2L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | VEO-XTI2L |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18762 MB |
