Ecler VEO-XTI2L handleiding
Handleiding
Je bekijkt pagina 31 van 85
31
It is also possible to add Net String buttons, in order to operate these devices using
control commands. This operation is described in the "Ecler VEO-XTI2L and VEO-XRI2L
TCP-IP Control Manual" document associated with this user guide.
10 CONFIGURATION USING VEO XTI2L - XRI2L CONTROL CENTRE
If any of the devices has firmware that is older than version 2.00r0, it will not be
compatible with EclerNet Manager. In this case, the only available way to manage the
equipment will be by means of the VEO-XTI2L - XRI2L Control Centre utility software
for PC. Once the software is installed, make sure that the PC and the VEO devices are
within the same network domain. To check the IP address of the devices, refer to the
‘How to find out the IP address of devices’ chapter.
10.1 How to find devices using Control Centre
Run the software and the device scan page will appear. Click on the "Start Scan" button
to search for active devices on the network, and find out their IP address. By default, both
transmitters and receivers are set to "Unicast" and "Auto IP" mode.
Bekijk gratis de handleiding van Ecler VEO-XTI2L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | VEO-XTI2L |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18762 MB |
