Durkopp Adler D867 e-con handleiding
Handleiding
Je bekijkt pagina 40 van 286
Operation
38 Operating Instructions D867 e-con - 00.0 - 06/2023
11. Turn the bobbin on the bobbin shaft (5) until the drive dog
spring audibly clicks into place in the slot of the bobbin.
12. Pull the bobbin winder lever (4) up.
The winding process starts and ends automatically when the
bobbin is full. The bobbin winder lever (4) returns to its lower
position.
Information
The hook thread is normally wound on when sewing is in progress.
However, you can also wind on the hook thread without sewing,
e. g. if you require a full bobbin in order to start sewing. For this
purpose, use Bobbin Wind mode in Manual mode ( p. 122).
13. Pull off the full bobbin.
14. Tear off the thread behind the knife (6).
15. Insert the full bobbin into the hook ( p. 38).
4.7 Changing the bobbin
WARNING
Risk of injury from needle tip and moving parts!
Puncture, cutting and crushing possible.
Turn off the machine before changing the bobbin.
NOTICE
Property damage may occur!
The surface of the bobbin may become damaged, causing
the bobbin rotation monitor to stop working correctly.
Do NOT use sharp parts to remove the bobbin!
Bekijk gratis de handleiding van Durkopp Adler D867 e-con, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D867 e-con |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 32197 MB |
