Durkopp Adler D867 e-con handleiding
Handleiding
Je bekijkt pagina 39 van 286
Operation
Operating Instructions D867 e-con - 00.0 - 06/2023 37
To wind the hook thread:
1. Fit the thread reel on the reel stand.
The unwinding bracket must stand directly above the thread
reel.
2. Feed the thread from the rear to the front through the thread
guide on the unwinding bracket.
3. Insert the thread in a wavelike manner through the first 2 holes
of the thread guide (3): from left to right through the first hole
and from right to left through the second hole.
4. Feed the thread through the third hole of the thread guide (3)
from left to right before feeding it clockwise around the pre-
tension (2).
5. Feed the thread from the right to the left through the fourth
hole of the thread guide (3).
6. Feed the thread from the left to the right through the upper
hole of the thread guide (1).
7. Feed the thread from the right to the left through the lower
hole of the thread guide (1).
Fig. 17: Winding the hook thread (4)
8. Guide the thread to the winder (7).
9. Clamp the thread behind the knife (6) and tear off the loose
end behind it.
10. Fit the bobbin on the bobbin shaft (5).
(4) - Bobbin winder lever
(5) - Bobbin shaft
(6) - Knife
(7) - Winder
④
⑦
⑥
⑤
Bekijk gratis de handleiding van Durkopp Adler D867 e-con, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D867 e-con |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 32197 MB |
