Durkopp Adler D867 e-con handleiding
Handleiding
Je bekijkt pagina 220 van 286
Troubleshooting
218 Operating Instructions D867 e-con - 00.0 - 06/2023
1207 Information Position not reached
(during bartack)
• Check the controller settings and change
them if necessary (e.g. thread trimmer
setting, belt tension, etc.)
• Check position thread lever at top dead
center
1302 Error Failure with sewing motor
current
• Check Service Stop
• Check for stiff movement
• Replace encoder
• Replace motor
1330 Error No response from sewing
motor
• Perform software update
• Replace the control
2101 Error Stepper card X30 reference
drive timeout
• Check reference sensor
2105 Error Stepper card X30 blockage • Check for stiff movement
2121 Error Stepper card X30 encoder
plug (Sub-D, 9-pin) not
connected
• Connect encoder cable to the control, use
correct connection
2122 Error Stepper card X30 flywheel
position not found
• Check stepper motor 1 for stiff movement
2130 Error Stepper card X30 not
responding
• Perform software update
• Replace the control
2131 Error Stepper card X30
initialization failure
• Perform software update
• Check selection of class
2152 Error Stepper card X30
overcurrent
• Check for stiff movement
2171 Error Stepper card X30 watchdog
(Stitch length)
• Perform software update
• Check selection of class
2172 Error Stepper card X30 motor
overload / overvoltage /over-
current (Stitch length)
• Check selection of class
• Replace the control
• Replace encoder
• Replace stepper motor
Code Type Possible cause Corrective
Bekijk gratis de handleiding van Durkopp Adler D867 e-con, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D867 e-con |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 32197 MB |
