Draper D20 60508 handleiding
Handleiding
Je bekijkt pagina 16 van 24
9. OPERATION
9.1 INSTALLING/REMOVING
BATTERY PACK – FIG.3
To install:
− Insert the battery pack.
− Make sure the latches on each side of the
battery pack snap into place and the battery
pack is secured in the product before beginning
operation.
To remove:
− Depress the latches on each side of the battery
pack.
− For complete charging instructions, see the
operator’s manuals for your battery pack and
charger.
9.2 TURNING THE ENGRAVER/
GRINDER ON/OFF – FIG.4
− To turn the tool ON: move the ON/OFF switch
(3) to the ON position.
− To turn the tool OFF: move the ON/OFF switch
(3) to the OFF position.
9.3 INSTALLING/REMOVING
ACCESSORIES – FIG.5
Notice: To prevent damage to the spindle or spindle
lock, always allow motor to come to a complete stop
before engaging the spindle lock.
To install:
− Remove the battery pack.
− Slide the spindle lock lever forward and rotate
the shaft by hand until the spindle lock engages
the shaft, preventing further rotation.
− With the spindle lock engaged, use the collet
wrench (12) to loosen the collet nut (5), if
necessary.
− Insert the shank of the accessory into the
collet until the shank bottoms out, then pull
it out 1/16" to allow for expansion when the
accessory gets hot.
− With the spindle lock engaged, tighten the
collet nut (5) with the provided wrench until
the accessory shank is gripped by the collet.
Avoid excess tightening of the collet nut (5).
To remove:
− Remove the battery pack.
− With the spindle lock engaged, loosen the collet
nut (5) with the provided wrench (12).
− Remove the accessory.
– 16 –
(3)
(12)
3 FIG.
4 FIG.
5 FIG.
(5)
Bekijk gratis de handleiding van Draper D20 60508, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Draper |
| Model | D20 60508 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2581 MB |
