DJI O4 Air Unit Pro handleiding
Handleiding
Je bekijkt pagina 10 van 23
S.Bus
GND
TX
RX
GND
VCC
Red
红
Black
黑
White
白
Gray
灰
Brown
棕
Yellow
黄
VCC Red Power
DJI O4 Air Unit: 3.7-13.2 V
DJI O4 Air Unit Pro: 7.4-26.4 V
GND Black Power GND
Receiver White UART_RX (Connects to ight controller OSD TX, 0-3.3 V)
Transmitter Grey UART_TX (Connects to ight controller OSD RX, 0-3.3 V)
GND Brown Signal GND
S.Bus Yellow DJI HDL (Connects to ight controller S.Bus, 0-3.3 V)
2. Install the video transmission module with screws.
3. There are directional requirements for the camera installation, make sure to
distinguish the upward direction according to the gure. Install the camera module
with the screws. Properly route the coaxial cable to avoid conicts with other cables.
4. Secure the antennas. Make sure the antenna extends out of the aircraft frame and is
not obstructed by any structural parts. It should be at least 5 cm away from the video
transmission and camera modules, and as far as possible from metal and carbon
ber structural parts.
DJI O4 Air Unit User Manual
10 © 2025 DJI All Rights Reserved.
Bekijk gratis de handleiding van DJI O4 Air Unit Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DJI |
| Model | O4 Air Unit Pro |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1631 MB |
