DeWalt DCMWSP660 handleiding
Handleiding
Je bekijkt pagina 53 van 228
11
EnGLIsh
To actuate the fuel gauge, press and hold the fuel gauge
button
62
. A combination of the three green LED lights will
illuminate, designating the level of charge left. When the level
of charge in the battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to berecharged.
nOTE: The fuel gauge is only an indication of the charge left on
the battery pack(s). It does not indicate tool functionality and is
subject to variation based on product components, temperature
and end-userapplication.
Safety Key (Fig.T)
DANGER: Sharp moving blade. In order to prevent
accidental start-up or unauthorized use of your cordless
mower, a removable safety key has been incorporated into the
design of your mower. The mower will be completely disabled
when the safety key has been removed from themower.
DANGER: Rotating blades can cause serious injury.
To prevent serious injury, turn unit off and remove safety
key and battery pack(s) when unattended, or when
charging, cleaning, servicing, transporting, lifting, or
storingmower.
1. Insert safety key
6
into the key slot
40
, located on the main
handle
4
, until it is fully seated inside of the keyslot
40
as
shown in Fig. T.
2. The mower is nowoperational.
LED Dashboard Indicators (Fig.A, U)
The control panel
12
contains the state of chargeindicator,
load meter indicator, temperature indicator, handle folding
indicator, blade sharpening indicator and resetbutton.
State of Charge Indicator (Fig.U)
The mower is equipped with a state of charge indicator. This
will display the current level of charge in the battery during
use. It does not indicate tool functionality and is subject to
variation based on product components, temperature and
end-userapplication.
• The state of charge indicator LEDs
17
will illuminate,
indicating the percent of charge in the battery.
• When all 5 state of charge indicator LEDs
17
illuminate, the
battery is fullycharged.
• When one state of charge indicator LED
17
illuminates,
charge is low and then it will flash when the battery
isdischarged. Remove thebattery and chargeit.
State of Charge Indicator LED Status
nOTE: Display will only indicate activated battery.
LEVEL OF CHARGE
CHARGE INDICATOR
LEDCOLOR
85% ‑ 100% White
70% ‑ 85% White
50% ‑ 70% White
25% ‑ 50% White
≤25% White
Low battery shutdown White and blinking
Handle Folding Indicator (Fig.U)
The handle folding indicator
15
will illuminate when the
single touch handle
1
is not engaged in the operating
position when the safety key
6
and battery pack(s)
27
are
installed, and the bail handle
8
is pulled. To clear the handle
folding indicator
15
, refer to the Raise the Single Touch
Handle section inthismanual.
Cutting Load Meter Indicator (Fig.U)
The cutting load meter indicator
14
will illuminate red to
indicate a high cutting load. Runtime will be reduced if there is a
prolonged high load while mowing.
Overheat Indicator (Fig.U)
• The overheat indicator
13
will illuminate amber and
then blink when the battery or motor is overloaded
duringoperation.
• The overheat indicator
13
will illuminate red and then blink
when the module has reached a high temperature.
• To clear the overheat indicator
13
, allow the battery and
mower
to cool down. When cooled, restart the mower
and
resume cutting with the mower deck sethigher.
Bekijk gratis de handleiding van DeWalt DCMWSP660, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DeWalt |
| Model | DCMWSP660 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 42588 MB |
