Handleiding
Je bekijkt pagina 21 van 40
2121
Apertura fascetta
(vedere tabelle iniettori)
Q P
Fig. 2.8
Ring opening
[mm]
REGULATION OF AIR SUPPLY TO
OVEN BURNER
Using a cross-head screwdriver, slacken the screw
“Q” securing the air ow regulation collar “P” (g. 2.8)
and turn the collar forward or backward to increase or
reduce the air aperture in accordance with gas type
and the indications in the ‘Table for the choice of the
injectors’.
Light the burner and check the ames.
ADJUSTMENT OF THE OVEN
BURNER MINIMUM
Considering that in the minimum position the ame
must have a length of about 4 mm and must remain
lit even with a brusque passage from the maximum
position to that of minimum.
The ame adjustment is done in the following way:
• turn on the burner by setting the thermostat knob
on position Max
(maximum);
• remove the knob and unscrew the by-pass screw
“G” (g. 2.9) about three times by passing a small
at screwdriver (Ø 3 mm blade, 100 mm length)
through the panel opening;
• re-mount the knob and let the oven heat up for
about 10 minutes, then bring the knob to position
130 (minimum) to operate the thermostat bypass;
• after having removed the knob again and being
very careful not to turn the tap rod, slowly screw
the by-pass screws “G” (g. 2.9) until you obtain a
ame of 3-4 mm in height.
N.B. For G30/G31 (LPG) the by-pass screw must be
xed thoroughly.
Fig. 2.9
G
Bekijk gratis de handleiding van Delonghi DSRM 905G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Delonghi |
| Model | DSRM 905G |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4287 MB |
