Definitive Technology Dymension Outdoor LS-6.1 handleiding
Handleiding
Je bekijkt pagina 5 van 33
4
English
Polarity Burial Wire Speaker Pigtail
+ White Red
- Green Black
Left Amp Channel
Polarity Burial Wire Speaker Pigtail
+ Red Red
- Black Black
Right Amp Channel
6. Installing the Satellite Speakers
IMPORTANT: Ensure the speaker load presented to the amplifier is within its published specifications. Do not connect
more than four satellite speakers to an amp channel. Miswiring may result in an unacceptable load, which might damage
the amplifier.
Using 4-Conductor Direct-Burial Wire
1. Unwind the 4-conductor wire spool towards the amplifier from the furthest speaker, leaving the wire attached to
the spool at the amplifier end. Do not connect the wires to the amplifier at this time.
2. Starting at the speaker furthest from the amplifier, strip 3/4" of insulation on the cut end of the burial wires for the
appropriate amp channel according to the tables below, then strip insulation from the ends of the corresponding
speaker’s pigtail. Wrap any unused wires in electrical tape to protect them from moisture and short-circuiting (see
Figure 4).
3. Connect the burial cable to the speaker pigtail using a
wire tie (see Figure 4).
4. Twist to combine all the positive (+) wires together and
combine all the negative (-) wires together according to
the tables below.
5. Twist the provided silicone-filled wire nuts onto the
combined positive wires and onto the combined
negative wires, ensuring that no copper is exposed.
Wrap each wire nut connection in electrical tape to
protect it from moisture.
6. Leave 14-16" of excess wire at the speaker so that the
wire doesn’t kink or pull taut during burial, then move to
the next speaker along the cable.
7. At the next speaker, use a round cable stripper or utility
knife to remove 8" of the outside wire jacket, exposing
the four insulated wires.
8. Cut the correct two wires for the left or right speaker
(see the tables below) and strip 3/4" of insulation on
the exposed ends of the burial wires, then strip 3/4"
insulation from the ends of the corresponding speaker’s
pigtail (see Figure 5).
9. Create a loop of approximately 10", and use a wire tie
to hold the wire loop and speaker pigtail in place to
provide strain relief (see Figure 5).
10. Repeat steps 4-6 then continue for each remaining
satellite along the cable. For subwoofer installation, see
section 7 “Installing the Subwoofer.“
Figure 5
+
_
FROM AMPLIFIER TO NEXT SPEAKER
Figure 4
+
_
ADD ELECTRICAL
TAPE TO EACH
WIRE END
FROM AMPLIFIER
Satellites Per
Amp Channel
Subwoofer
Connected
Channel Load
Impedance
1 No 32Ω
2 No 16Ω
3 No 11Ω
4 No 8Ω
Satellites Per
Amp Channel
Subwoofer
Connected
Channel Load
Impedance
1 Yes 6.4Ω
2 Yes 5.4Ω
3 Yes 4.6Ω
4 Yes 4Ω
Impedance per amplifier channel with speakers/subwoofer connected in parallel
Bekijk gratis de handleiding van Definitive Technology Dymension Outdoor LS-6.1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Definitive Technology |
| Model | Dymension Outdoor LS-6.1 |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 4026 MB |
