CYP IP-7000C-TX handleiding
Handleiding
Je bekijkt pagina 10 van 48
5
7
IR Window: Accepts IR signals from any standard remote control and
sends the signal to the IR Out on the associated receiver.
Note: When the transmitter is in multicast mode the IR signal is sent to all
associated receivers.
8
SWITCH/LINK Button: This button controls the following functions:
Switch: Press this button momentarily to switch the input video
source.
Video Link: Press and hold the button for 3 seconds to enable or
disable the streaming link with the currently routed receiver. When
the link is disabled, and the receiver is connected to a display, it will
show the system’s current IP and rmware information.
Reset to Factory Defaults: Press and hold this button when
powering the unit on until both the POWER and LINK lights are
blinking. Once both lights are blinking you can reboot the unit
and all settings will be returned to the factory defaults (Including
resetting the IP mode to auto, broadcast channel to 0, and the
streaming mode to multicast). A new IP address will be assigned
automatically within the 169.254.xxx.xxx address range.
9
MODE/Anti-DITHER Button: This button controls the following
functions:
Video Mode: Press this button momentarily to toggle the video
data streaming method between “Graphic” and “Video” modes.
“Graphic” mode is optimized for high-detail static displays and
“Video” mode is optimized for full motion video.
Anti-Dither: Press and hold this button for 3 seconds to switch
between the three “Anti-Dither” modes (1-bit, 2-bit, and o).
Note: Certain graphics cards use dithering to emulate a larger colour
palette, but dithering causes diculty for maintaining low-bandwidth
during real-time video compression. These modes are designed to
remove the dithering prior to compression and transmission of the
signal. The Anti-Dither feature is set to “o” by default. If the source is
not using dithering, please leave this feature disabled as it may cause a
blocking eect with non-dithered content.
10
ISP Pinhole: This is for factory use only.
11
RESET Pinhole: Press this recessed button to reset the unit’s power
supply and reboot the unit.
Note: Settings will not be reset.
Bekijk gratis de handleiding van CYP IP-7000C-TX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | IP-7000C-TX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3554 MB |
