Curtis 700 handleiding
Handleiding
Je bekijkt pagina 18 van 23
16
701 Hour Meter continued
To Operate: Apply DC+ or AC hot to pin 3 for
1/2 second minimum (AC/DC model) or DC+ for
1 millisecond minimum (DC Only model). The accumulation
of elapsed time is indicated by the flashing hourglass
icon. If power (pins 1 & 2) has been applied for 5 seconds
minimum, the accumulated time will be stored in non-
volatile memory when power is removed.
To Reset: (for resettable models) Apply DC+ or AC hot to
pin 4 for 1/2 second minimum while power (pins 1 & 2) is
applied for 5 seconds minimum. The reset voltage must be
at the same level as the voltage used to power the unit.
703 Counter (AC/DC or DC Only)
To Display: Apply DC+ or AC hot to pin 1 and DC – or AC
neutral to pin 2. The display is activated at this point but
the count will not be started until a signal is applied to pin
3. Note, for proper operation: Power must be applied to
pins 1 & 2 before or coincident with pin 3.
To Operate: Apply DC+ or AC hot to pin 3. The count is
incremented when the input signal is removed from pin 3.
Bekijk gratis de handleiding van Curtis 700, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Curtis |
| Model | 700 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1078 MB |
