Curtis 700 handleiding
Handleiding
Je bekijkt pagina 17 van 23
15
4. OPERATION
NOTE: All models display an 8 in all digits for
1 sec. at power-up.
700 Hour Meter (AC/DC)
To Display & Operate: Apply DC+ or AC hot to pin 1
and DC – or AC neutral to pin 2. The accumulation of
elapsed time is indicated by the flashing hourglass icon.
If power has been applied for 5 seconds minimum, the
accumulated time will be stored in non-volatile memory
when power is removed.
To Reset: (for resettable models) Apply DC+ or AC hot
to pin 4 for 1/2 second minimum while power (pins 1 &
2) is applied for 5 seconds minimum. The reset voltage
must be at the same level as the voltage used to power
the unit.
701 Hour Meter (AC/DC or DC Only)
To Display: Apply DC+ or AC hot to pin 1 and DC– or
AC neutral to pin 2. The display is activated at this point
but the elapsed time will not be accumulated until a
signal is applied to pin 3. Note, for proper operation:
Power must be applied to pins 1 & 2 before or coincident
with pin 3.
Bekijk gratis de handleiding van Curtis 700, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Curtis |
| Model | 700 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1078 MB |
